Accessories

ADHESIVE is used for gluing holders in plastic to PVC membrane roofing.

Substrate and ambient temperature during application and binding should be from +15°C to +25°C
Drying time: about 10 - 30 min.

Method of application:

1. The surfaces should be thoroughly degreased.
2. Mix the content of the bucket.
3. Apply the adhesive with a brush on both sides on the surfaces.
4. Wait 10 min.
5. Check it with your finger (there should be no wet spots on the surface).
6. Place the holder and press it firmly against the roofing.

Properties:

• has excellent adhesive properties,
• has very good adhesion to the PVC membrane,
• resistant to weather conditions, high and low temperatures,
• resistant to short and long-term aging,
• easy and quick to use, can be applied with a brush

The adhesive mass is used for gluing plastic holders to roofing felt.

Substrate and ambient temperature during application and bonding: from +5°C to +25°C
Drying time: 24h

Method of application:
1. Thoroughly mix the content of the bucket.
2. Apply a small amount of glue to the holder with a spatula and the
place where holder should be glued using the "glue to glue" method.
3. Wait 20 minutes.
4. Place the holder and press it against the roofing.

Properties:

• modified SBS,
• has excellent adhesive properties,
• has very good adhesion to the roofing felt,
• resistant to weather conditions, high and low temperatures,
• resistant to short and long-term aging,
• easy and quick to use

!!! CAUTION!!!
Do not use to cover PVC, EPDM membranes.

The adhesive strap is used for mounting (gluing) concrete holders in plastic (plastic base), on a steel base for metal roofing, parapets, etc.
Properties:
- one-component product,
- convenient application in the form of tapes cut as needed,
- excellent adhesion to substrates without primers,
- UV resistant,
- permanently elastic.

ATTENTION ! Do not use for PVC, EPDM membrane type coverings

Method of application:
1. Cut the straps to the correct length (see assembly scheme).
2. Stick the adhesive strap to the holder according to the assembly scheme.
3. Remove the protective paper.
4. Place the holder and press it against the roofing material.

ASSEMBLY

The membrane fixing strap is used to mount the swivel stand: B641536
concrete support in material: B931508
and a plastic holder: B641556

It should be installed by welding the strip to the roofing material.
Fastening strap dedicated to PVC membrane covering.

ASSEMBLY
B931508	B641556	B641536

The sealing collar is used to seal the ground wire through the roof.
The product is dedicated to PVC membrane covering.

It should be installed by welding the collar to the roofing.
Supplied with a snail clamp.

ASSEMBLY:

A product used to seal the place where lightning conductors pass through the roof. Made of the IGOM CE material. The collar is welded to the heat-weldable roofing felt, providing a tight connection and protection against water under the waterproofing. Supplied with a snail clamp.

A - conductor clamp B - a sealing collar where a conductor passes through C - waterproofing layer D - a layer of heat-sealing felt E - vapor barrier F - a layer of heat-sealing felt G - ceiling

Used to secure threaded connections.

Used to secure threaded connections.

For anti-corrosion protection of constructions and elements.

Soft and flexible anti-corrosion tape for protection against corrosion of lightning connections in the ground (flat wire - flat wire, flat wire - round wire). It is characterized by flexibility at low temperatures and resistance to rodents.

Advantages of AN-KOM anti-corrosion tape:
- easy and quick application,
- tape based on waxes and paraffins,
- resistant to rodents and rot.